4.00.B55 | Enhancements:
1.Support Loopback Detection v4.0 (a. STP independent, b. Per port or per VLAN shutdown option when there is a loop detected).
2.Support IEEE802.1v Protocol-based VLAN.
3.Support MLD snooping v1/v2.
4.Configurable RIP Timers: Update interval, Timeout interval, Garbage_collection interval.
5.Support OSPF Equal Cost Route: Max. ECMP number of a route is 8.
6.Support
Host-based IGMP Fast Leave: When enabling IGMP Fast Leave, the default
behavior is Host-based and this is not changeable. 1K host table is
supported.
7.Support 2nd default route: Primary/backup route is supported. ECMP is not supported.
8.Support IPv6 Awareness: IPv6 ACL, IPv6 Classification - DSCP Remarking.
9.Support Per Flow Bandwidth Control.
10.Safeguard Engine Enhancement: Limit the bandwidth for ARP Request/IP Broadcast instead of blocking them in previous releases.
11.Add logout timer for Web-based Access Control.
12.Support IP-MAC Port binding v3.3 (with DHCP Snooping).
13.Support DHCP Server.
14.Support Loopback IP Interface: Up to 2 Loopback IP Interfaces.
15.The number of terminal lines on the display is configurable.
16.Enhance
the Web UI for finding a MAC Address in MAC Address Table. Before this
release user must key in MAC address with "-", for example
"12-23-34-45-56-67".
17.Display remaining ACL rules on Web/CLI.
18.Allow User level of accounts to execute “ping” command.
19.Stop contacting to TACAS+ server periodically before logging-in.
20.Rename "DLF" to "Unicast" in Traffic Control feature.
21.Enhancement
for 3-Level User Access Right feature: Disallow user to execute "enable
admin" command when authenticating using local or Radius database.
TACAS/TACAS+/XTACAS users still can execute "enable admin" because
TACAS/TACAS+/XTACAS do not support user level definition.
22.Add an OID to show port utilization.
23.Enhancement
for per port limited IP multicast address range: Support up to 24
profiles and each profile can add up to 128 multicast groups. Max
multicast group per port can join is configurable and the max number is
256.
24.Add a command “show access_profile current_config” to display
the user-configured access profiles. (The existing “show
access_profile” command displays all access profiles configured not only
by users but switches.)
25.Change link of D-Link logo to
www.dlink.com.tw. This web site will redirect HTTP requests to the
regional D-Link web site of each country.
26.Enhancement for
MAC-based Access Control, Web-based Access Control, and 802.1X: If a
VLAN assigned from the Radius server does not exist on the switch, the
switch will not assign this VLAN to the port.
27.New Web panel on Web UI.
28.Allow
untag VLANs to overlap on a port. 29.Upgrade Bridge-MIB from
rfc2674.mib to rfc4363.mib.v 30.Combo port configuration: copper port
and fiber port can be configured separately.
31.A private MIB that can clear ARP & Forwarding table.
32.A private MIB that can advertise tag when creating VLAN | 11/12/2008 | |
very helpful! Here you will get all kind of solution like
ReplyDeleteD-link australia
dlink admin password
D-link Customer Support